nav[aria-label="Primary Navigation"] { padding: 0; & ul { list-style: none; width: 100%; display: flex; flex-direction: row; justify-content: start; align-items: start; gap: 30px; padding: 0; & li { margin: 0; } & ul li { list-style: none; } } }

R510 AP no internet

coltenroberts88

I have three APs, all of which are R510. two of them work fine, the other 1 does not. It has the Power light green and CLT light blinking slowly.

I've tried switching ethernet ports and continue to have the issue.

I've done a hard reset, and then tried to connect through my phone. It will say im connected, but the wift bands at the top of the phone never show up. In the app i get the following error, "Un-leashed, You are connected to config me however the connection to the unleashed AP is not established yet. Please wait for the WiFi symbol to appear at the top status bar before continuing"

I've waited close to an hour without it connecting.

Find more posts tagged with

Accepted answers

All comments

imran.sanadi@commscope.com

Hi @coltenroberts88

Greetings!!!

Thank you for contacting RUCKUS Lennar Home Community.

Hope you are doing well!!!

Thank you for the information you shared.

As per the case description, I understand that one of your 3 RUCKUS R510 Access Points is not working with CTL and PWR light blinking.

Could you please let me know to which port of the RUCKUS ICX-7150-C12P Switch the affected AP is connected? Please share the picture of the same, as shown in the below screenshot.

Before uploading the photos, please log in to the RUCKUS account and you can upload the image.

Please let me know the answer to the above query or let me know if you have any queries in this regard.

Thank you again for your patience.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

coltenroberts88

The arrow is pointing to the AP that is not working.

imran.sanadi@commscope.com

Hi @coltenroberts88

Thank you for the response and the information you shared.

The connections and light status of the Switch seem to be normal, now we may need to factory reset the APs to configure them with a new SSID.

IMPORTANT NOTE: To perform a factory reset correctly on one of the access points, you must disconnect the rest of your other access points from the "ICX-7150-switch". For example, if you have 3 access points, you should go to the switch and disconnect 2 of the cables to turn off the "2 access points" and only leave 1 connected with which we are going to work the factory reset once you configure the access point and make sure all is good, go ahead and reconnect the other Access Points back.