Set IP address of switch using 10.0.10a

Question

Hello,

I am using a ICX7550 that i have updated to the lastest FastIron 10.0.10a. 
from reading i understand that the ip adress is handeled differently in 10.x versions, and i cant quite figure it out.

I want to add an ip address to one interface that is NOT an management interface. that i want to be able to access the system network and tftp to the switch on the same interface. I believe you call it an inband port? I want to be able to access both my network and the switch from the same port.

The manual suggest to look in the Hardware installation guide. but that guide instructs to enter configuration mode for the interface and write  "ip adress x.x.x.x/24" which to my understanding only works for 9.0.x and not for version 10.
so how do i achieve this setting of IP on the new firmware (10.0.10a)?

Thanks! 
/Ludvig

Chandini · Answer

Hi Ludvigb

Ack and Noted. Thanks for sharing.

That's correct you will be unable to configure ip on a interface which is a part of "ve" interface. You will need follow the below steps to assign a ip address on a port.

* Make sure the port is not a part of any "ve" interface
* Enable below command on the interface * ICX7550-48ZP Router(config)#int e 1/1/1
* ICX7550-48ZP Router(config-if-e1000-1/1/1)#route-only
* ICX7550-48ZP Router(config-if-e1000-1/1/1)#ip address 1.1.1.1/24

* In running configuration you will view as below when you give command "show run interface e 1/1/1"* ICX7550-48ZP Router(config)#show run int e 1/1/1
interface ethernet 1/1/1
route-only
ip address 1.1.1.1 255.255.255.0
!
ICX7550-48ZP Router(config)#

I hope this helps

Thanks

LudvigB · Answer

Hello, 
here are screenshots of when i write IP and then tab for options. and slow show version as you request. Thanks for looking into the issue.

Edit: remved pictures

regards,

Chandini · Answer

Hi LudvigB

Ack and Noted. Thanks for reverting.

Could you please share output of "Show version" from the switch ?

Thanks