Hello!
Upon arriving home, I noticed some of my smart home devices were not functioning at all. Took a look at the network panel, and found that the SYST light was amber on the switch.
I did find multiple posts about trying to do a software recovery, but every time I PuTTy into the console, I can’t type anything. If I try to reboot the switch while still connected to the console, I can see its boot sequence failing > but then it starts writing a TON of dashes on the screen, “>t>t>t”, and some other gibberish. Nothing happens when I try to press enter.
I’ve tried factory resetting by holding the reset button while powering on. All the LEDs do flash amber, but it didn’t do anything else but flash for about an hour. Consoled in again, but same issue.
What can I do to get this switch back up and running? Any help is much appreciated!
