I recently purchased a home with ruckus installed already. Need help accessing (e.g password) ruckus network
Hi @galbreath52
Most often the default password for access points and ICX - 7150 - C12 P are
Username:admin password: Ruckus!
Username:admin password: Ruckus1
Username:admin password: Lennar
Username:super password: sp-admin
Admin usernames and passwords for the Ruckus Wi-Fi Access Points/Switch for Lennar home users
https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/Admin-usernames-and-password...
Note : This is sensitive to the keys so it must go with the capital letters indicated
If you want to reset the Access Point ( white box on the ceiling ) Read the following guide carefully, you must disconnect the other access points from the Ruckus Switch by disconnecting the Ethernet cable and only leaving 1 connected in which you are going to work the factory reset.
Physical Factory Reset an Access Points Ruckus
https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/Physical-Factory-Reset-an-Ac...
If you want to process a factory reset the ICX-7150-C12P default password is ( username:super password : sp-admin )
Please try to press the reset button using a paper click or a small stick
https://docs.commscope.com/bundle/icx7150-installguide/page/GUID-D3B5DB74-53A7-4F8D-82F9-6EB600879EE...
Video link:https://www.youtube.com/watch?v=6jHMTdo_hK4
If that does not work you need to console the ICX-7150-C12P in order to preform a password recovery using a ( ( ICX 7150 -C12P ) USB type C to USB- ( PC ) cable ) or ( ( ICX 7150 C12P ) - Rj45 to USB- ( PC ) cable )
Here a short guide :
How to console in the ICX-7150-C12P
https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-console-in-the-ICX-71...
Password recovery
https://www.youtube.com/watch?v=XJS28DWbHM4&t=94s
1.Start a CLI session over the serial ( console access) interface to the RUCKUS ICX device.
2-Enter OS mode. This uses a key combination and drops below the fastiron operating system
Key Combination: Ctrl+y, release, tap 'm', tap 'Enter'
OS>
4-just write reset
OS>reset
5-.While the system is booting, before the initial system prompt appears,enter b to enter the boot monitor mode.
Enter 'b' to stop at boot monitor: 0
In this Part you have to press B before the counter ends
6-Enter no password. (You cannot abbreviate this command.)
ICX7650-Boot> no password00 00 00 00OK! Skip password check when the system is up.
7-Enter boot. This command causes the device to bypass the system passwordcheck.
ICX7650-Boot> boot
8-After the console prompt reappears, assign a new password.
Best regards,
Jayavidhya
Lennar Home Community
This did not work. I cannot ping 192.168.0.01.
