Cannot disable HTTP access / ICX 7150-c12p

Question

All,

I have recently been working with the 7150-c12p to replace some Cisco 2960cx. I am beginning to find missing features (energy efficient ethernet, perpetual poe and slower reload times).

One that I have been unable to figure out is how to disable HTTP access. I can access both HTTP and HTTPS even when running "no web-management http" using "show web" shows both enabled and I confirmed both are accessible. Running 08.0.95g.

Thanks ahead of time,

Chandini · Answer

Hi Team

This is a tested output from firmware 8095h

ICX7150-C12 Router(config)#show flash
Stack unit 1:
NAND Type: Micron NAND 2GiB (x 1)
Compressed Pri Code size = 33554432, Version:08.0.95hT213 (SPR08095h.bin)
Compressed Sec Code size = 31457280, Version:08.0.95dT211 (SPS08095d.bin)
Compressed Pri Boot Code size = 786944, Version:10.1.25T225 (mnz10125)
Compressed Sec Boot Code size = 786944, Version:10.1.19T225 (mnz10119)

By default you will have http enabled and https disabled

ICX7150-C12 Router(config)#show web

HTTP server status: Enabled
HTTPS server status: Disabled
No web connection.
ICX7150-C12 Router(config)#

I tried to disable using no web-management http and the http status is disabled

ICX7150-C12 Router(config)#no web-management http
ICX7150-C12 Router(config)#show web

HTTP server status: Disabled
HTTPS server status: Disabled
No web connection.
ICX7150-C12 Router(config)#

I hope this helps. Thanks

BenBeck · Answer

Hey @Knowguy

You would need to purchase a support contract if you do not have active support. Without that, we will not give official support to you. With that said, I will make note of the issue and take a look time permitting.  Just to confirm, are you getting the web gui and can log in even with the service disabled? Or are you just getting a landing page and unable to log in?

Knowguy · Answer

@BenBeck Someone will have to open a case for me, while I can open one support will not engage since I do not have an active support agreement.