Replaced Modem and APs stop working

Bruskins

Decided to swap out my Xfinity rental modem/router (TG02DCW4482CT), for a Motorola (MB8600-10), a modem-only, which is known to be compatible with Xfinity’s system.  Already present in the home are a Ruckus Router (ICX 7150-C12P), and two APs (R510 Series), which all work admirably.

Upon switching to the Motorola modem, hard lines coming from the 7150 continued working, while the APs failed to emit wifi.  Any thoughts?

Yarenis

Hi @Bruskins

The main problem here is that the Motorola modem (MB8600-10) does not run two important protocols, DHCP and NAT, for a one to one connection it works, but everything else that is connected to the ICX7150 switch will not get a connection/IP address, This is because the previous router was in charge of the DHCP protocol (IP addressing assignment), now the Switch and the AP can be configured to run DHCP, the problem is that the modem does not have NAT, which is the second protocol that we use to do the routing between the devices locally to the internet, this is why for Lennar home set up, we use a router or gateway connected to the ICX7150 Switch, hope this information can clarify your doubt.

 

Best regards,

Yarenis Hernández

Technical Support Engineer | L2 TAC Wired