How do I know if my switch has route image or switch image?
Does this R indicates router mode? Is there any way I can know this from show flash itself or some other command which doesn't need booting with image first?
UNIT 1: compiled on Dec 17 2014 at 18:38:51 labeled as FCXR08010g
Stack unit 1:
Compressed Pri Code size = 7280225, Version:08.0.10gT7f1 (/foundry/FGS/os/FCXS08010g.bin)
Compressed Sec Code size = 9675881, Version:08.0.10gT7f3 (/foundry/FGS/os/FCXR08010g.bin)
Compressed Boot-Monitor Image size = 370695, Version:10.1.00T7f5
Code Flash Free Space = 48234496
sh version
Copyright (c) 1996-2014 Brocade Communications Systems, Inc. All rights reserved.
UNIT 1: compiled on Dec 17 2014 at 18:38:51 labeled as FCXR08010g
(9675881 bytes) from Secondary /foundry/FGS/os/FCXR08010g.bin
SW: Version 08.0.10gT7f3
Boot-Monitor Image size = 370695, Version:10.1.00T7f5 (grz10100)
HW: Stackable ICX6610-48
==========================================================================
UNIT 1: SL 1: ICX6610-48 48-port Management Module
Serial #: BXL1312K0HH
License: ICX6610_PREM_ROUTER_SOFT_PACKAGE (LID: dzpINGKnFjp)
P-ENGINE 0: type E02B, rev 01
P-ENGINE 1: type E02B, rev 01
==========================================================================
UNIT 1: SL 2: ICX6610-QSFP 10-port 160G Module
==========================================================================
UNIT 1: SL 3: ICX6610-8-port Dual Mode(SFP/SFP+) Module
==========================================================================
800 MHz Power PC processor 8544E (version 0021/0023) 400 MHz bus
65536 KB flash memory
512 MB DRAM
STACKID 1 system uptime is 7 days 19 hours 48 minutes 51 seconds
The system : started=warm start reloaded=by "reload"
