I am trying to factory reset my Ruckus R710 access point, but have trouble doing so. After pressing the reset button for 10 seconds, the PWR LED turns red and the AP seems to be factory resetting. Connecting to the AP by directly connecting an ethernet cable and setting an IP in 192.168.0.x/24 shows that the AP replies to ping on 192.168.0.1, but no web interface is shown. All lights on the AP are off except the PWR light, which is blinking green or solid green. Only the following ports seem to be open:
Nmap scan report for 192.168.0.1
Host is up (0.00073s latency).
Not shown: 65533 closed tcp ports (reset)
PORT STATE SERVICE
1883/tcp open mqtt
18301/tcp open unknown
MAC Address: 58:B6:33:xx:xx:xx (Ruckus Wireless)
Nmap done: 1 IP address (1 host up) scanned in 2.47 seconds
The "island-xxxxxx" SSID is also being broadcasted, and I am able to connect to it with the device's serial number as password. However, I am not getting any IP address, except a link-local. The AP is then responsive on 169.254.1.1, but only on the ports shown above – no web interface or SSH.
When I connect the AP to my router it will get an IP address correctly, but it is unable to be seen by my Ruckus Unleashed install nor does it have any web interface or SSH. It replies to ping, but the only ports open are also the ones from above.
I have also tried to press the reset button for longer than 1 minute and the 30-30-30 method, but nothing changes.
Any ideas what I can do?
