How to access a locked out ICX 7250 with SPR08090ufi? console aaa enabled, no
local users

Question

Hello everyone, I've done a stupid thing, it seems.I did erase the startup config on an ICX 7250 with aaa console enabled. Result seems to be that I erased the users from the local db, but not the requirement to login with one of those users on the console CLI.Is there a way to fix this?

simon_pollard · Answer

HiFrom 8.0.90 any switch that does not have a startup-config file (which you have erased) will boot up with a default username and p[password, this is the same as we use for our APs;U: superP: sp-adminNote also that in 8.0.90 telnet is disabled by default and SSH enabled.

unknown · Answer

Thanks! That worked. I've searched for all kinds of phrases, but never thought of "lost password" because I thought in terms of "lost user".

vincent_felisaz · Answer

Hello,Did you try the reset password option? Here is the recovering from a lost password process.If a password has been 
configured for the device but the password has been lost, you can regain
 Super User access to the device using the following procedure.

Recovery from a lost password requires direct access to the serial port and a system reset.

Start a CLI session over the serial interface to the 
			 Ruckus ICX device.

Reboot the device.

While the system is booting, before the initial system prompt appears, enter 
			 b to enter the boot monitor mode.

Enter 
			 no password. (You cannot abbreviate this command.)

Enter 
			 boot. This command causes the device to bypass the system password check.

After the console prompt reappears, assign a new password.

Cheers