Hi Dominik,
Hope you are doing Great!!!
This is a command to copy image from Primary to Secondary flash.
Can you please get me output of "show flash", "show version" and "show run | i boot"
Also please tell me what version you are upgrading from and to?
Thanks
Hashim
Hi, I am trying to upgrade the switch trough vsz on remote location, so I cannot run that commands.
I can though send you last backup config and version I am trying to upgrade to is 08059d.
Last backup:
ver 08.0.90jT213!stack unit 1 module 1 icx7150-48p-poe-port-management-module module 2 icx7150-2-copper-port-2g-module module 3 icx7150-4-sfp-plus-port-40g-module stack-port 1/3/1 stack-port 1/3/3!!!!!vlan 1 name DEFAULT-VLAN by port!!!!!!!!!!!!!aaa authentication web-server default localaaa authentication login default localenable aaa consoleip dns server-address 8.8.8.8 8.8.4.4ip route 0.0.0.0/0 192.168.1.1 distance 254 dynamic!username super password 8 $1$KHaRHOxv$igh8FhuiC4TfWdUw/ioVS1!!!!web-management https!!sz registrar 34.90.89.117sz active-list 34.90.89.117 10.164.0.3!!!!!!!!!interface ethernet 1/1/1 ip address 192.168.1.3 255.255.255.0 dynamic!interface ethernet 1/3/1 speed-duplex 1000-full!interface ethernet 1/3/2 speed-duplex 1000-full!interface ethernet 1/3/3 speed-duplex 1000-full!interface ethernet 1/3/4 speed-duplex 1000-full!!!!!!!!!!!!!en
Thanks Dominik,
Seems like the failure is when the file is being copied from primary to secondary flash.
From your config you are booting from primary which is the default.
Steps to access switch console:
The SmartZone administrator must complete the following steps to access a CLI session.
Then you should be able to run the commands.
The failure is after the image is copied to primary the next step is copy of image to secondary from primary, which is where it is failing.
I do not have that CLI command
We can rectify using cli and tftp server or USB drive
copy tftp flash <tftp server ip address> filename primary
copy tftp flash <tftp server ip address> filename secondary
or USB
copy disk0 flash filename primary
copy disk0 flash filename secondary
@hashim_bharoocha
I sent you screenshot, I do not have CLI session to select from "More"
Please open a TAC case and work with our TAC team.
https://support.ruckuswireless.com/contact-us
Hope this helps
You have older version for it
