how to set default secondary Flash image

Question

Hi,

we are using ICX7150 switch for router feature, therefor i had use the below command for using secondary image and reload the switch in the secondary image. but, while i reboot the switch, its up by primary image only.

# boot system flash Secondary yes

Can you please help me to tell us how to set default secondary Flash image.

vincent_felisaz · Answer

Hi Muhammad,

You cannot jump directly from 08.0.30 to 08.0.95 as the UFI image type is not recognized. You need to have a step on 08.0.80 or 08.0.90 non-UFI version as an intermediate.

Hope this helps

Cheers

unknown · Answer

Hi Team,

I was configuring ICX7150-24 switch. But I noticed Routing Image was configured on Primary memory and Secondary memory. I have to configure Routing image in secondary and Switching image in Primary. Can you pls help me?

For reference image is attached

Thanks and Regards

vincent_felisaz · Answer

Hello,

just to clarify, starting 8.0.80 there is the introduction of Unified FastIron Image (UFI). This is recommended to have both flash with UFI images but not necessary the same type (Switching/Routing) or release.

No limitation here.

Cheers

Vince