ICS 7150-c12p / R510 X 2 setup question

Question

I about to close on my house which in installed with a ICS 7150-c12P + 2 access points R510.  They builder doesn't do the configuration themselves.  But have a installer we can setup a few weeks after we close.  But we seen / heard to many in the hood have trouble with this installer as it done incorrectly.

I am a computer network and repair guy by trade.  But have no experience with Ruckus.  I have read some forums and lots of youtube videos.

My  questions.

1. If want the 7150 DHCP to use 192.168.2.0 ranges do I setup this BEFORE I do the setup
using the configure-me wifi connection and connected to the unleash.

If so I do I setup the DHCP server on the 7150 and use the 192.168.2.0 range what the best steps.

Or is it best to connect to the web IP to the 7150 that I setup via the usb c console, change the 
DHCP.  Then do I start the R510 master and slave configuration.

2.  Are the 12 ports POE on by default?  Or is this a step that needs to be done prior to setup of the configure-me...  proces.

Thank You

kvamshi · Answer

Hi Dan,

I find myself in a similar situation. Ruckus shipped a replacement switch for me but now cannot figure how to setup the switch correctly . Did you ever figure this ? If you can link to specific steps I will appreciate. I am aware of the technical guides that have been posted by support personnel here but they are too vast and technical for me to follow

syamantakomer · Answer

Hi Dan,Could you check with your ISP, what type of internet connection they are providing?You can find Command referance guide, DHCP guide and management guide from below links for ICX switches.https://support.ruckuswireless.com/documents/3053-fastiron-08-0-92-ga-command-reference-guide/download https://support.ruckuswireless.com/documents/3059-fastiron-08-0-92-ga-dhcp-configuration-guide/download https://support.ruckuswireless.com/documents/3047-fastiron-08-0-92-ga-management-configuration-guide/download It is for 08092 version.

Regards,
Syamantak Omer

unknown · Answer

Thank you for your replay.

is there a good doc for a procedure of setting up a dhcp server on the 7150 and defining the network.

The second part of the this setup. To my best  understanding that is our isp deliveries a cat 6 cable directly to ourhome basement with a non static ip. We been told by neighbors we connect this cable to one of the 12 ports. Will a route or any setup need to be performed to have them see the internet via ths port?