nav[aria-label="Primary Navigation"] { padding: 0; & ul { list-style: none; width: 100%; display: flex; flex-direction: row; justify-content: start; align-items: start; gap: 30px; padding: 0; & li { margin: 0; } & ul li { list-style: none; } } }

All OSPF Disappears Once Upgraded

jgaye

I'm still new to RUCKUS, so please forgive any misunderstandings.

My predecessor didn't upgrade the firmware on the 7250 switches and now I'm doing it. I've noticed that some upgrade while others do not. I also noticed the ones that are 08.0.30 with compliant licenses have no issue upgrading to 08.0.95, but the ones that are non-compliant will not take 08.0.08D, then 08.0.08MC, lastly to the 08.0.95. OSPF is lost once upgrading to 08.0.08D.

Do I need to have a valid L3-Prem-LIC to get the L3 options once upgraded?

Find more posts tagged with

Firmware Upgrade

Hard reset

Accepted answers

BenBeck

'license install perpetual 1 l3-prem'

I don't have a 7250 in front of me, but do you have the above option? Or what are the options when you tab through it?

All comments

BenBeck

Yes. You do need a prem license for OSPF. It should not go away during an upgrade, so it is hard to say what is happening there. Once upgraded, please run a 'show license' to see what is there. On 8095, you should just be able to apply it again via CLI:

device# license install perpetual <tab-through-for-options>

jgaye

I will try this again in the morning and report back as the switch is in production. I tried license install perpetual 1 2x10g, and Y for yes to install, but OSPF still wouldn't appear. Just Router rip vrrp.

BenBeck

Check 'show license' and see what you have there. It's possible we need to clear the old licenses if something went wrong. 'license delete <tab>'

jgaye

Hm. Confused now. When I do Show License, there is no license, but the Show Version says I have a Non-Compliant license.

"License Compliance: ICX7250-PREM-LIC-SW is Non-Compliant"

BenBeck

'license install perpetual 1 l3-prem'

I don't have a 7250 in front of me, but do you have the above option? Or what are the options when you tab through it?

jgaye

I do have that option, #license install perpetual 1 l3-prem

BenBeck

If that doesn't work, please open a case and we can formally take a look.

jgaye

#License install was not an option. I had to go from 08.0.30h to 08.0.80D, then do #license install perpetual 1 L3-Prem, then go to 08.0.90MC, lastly, go to any UFI version.

Leaving this up as it took me weeks to figure this out since I mostly do Cisco. Hopefully, someone else finds this.

BenBeck

Interesting. The verified upgrade path from Engineering is old code > 8080f non-UFI > anything UFI. In theory, that should work although there are a ton of patches out there at this point. Thanks for sharing.