Ruckus ICX7150-C12P will not boot up

Rose_Jon

I am able to connect to the terminal console using PuTTY

When I issue a Powercycle command the Switch goes through a number of steps but the last output I see displayed is as follows:

iproc_nand_read_page returned 2

NAND read from offset 0 failed -22

 0 bytes read: ERROR

## loading kernel from FIT Image at 70000200 ...

Bad FIT kernel image format!

EROR: can't get kernel image!

ICX7150-Boot>

 

I'm not sure what the next step is to try to correct this problem.

Please Help

Rose_Jon

Hi, I followed all of the instructions you outlined.  You may have misunderstood the situation I am having.  I am able to connect to the switch with the console, but the switch will not complete a boot process.  I installed the TFTP program as directed, and I had already installed PuTTY and successfully connected to the switch.  I decided to download the same version of the software 08.0.90k as the instructions outlined.  I was able to complete the extraction and upload, updates  and saveenv of the boot and image files to the switch.  I followed that with a reset command to the switch and the switch seemed to go through the steps to boot but came up to the following error message on the console display.

NAND read: device 0 offset 0x4000000, size 0x2000000

3 ecc_errors after reading 5efa000:5efbc00

iproc_nand_read_page  returned 2

NAND read from offset 4000000 failed -22

 0 bytes read: ERROR

 Loading kernel from FIT Image at 70000200 ...

Bad FIT kernel image format !

Error: can't get kernel image !

ICX5150-Boot>

 

The switch has a green PWR light and an amber SYST light on the front panel all 12 network ports do not seem to be active when I try to connect a CAT 6 cable.  I do not think I am any closer to having a functioning switch.

I am open to other suggestions and thank you.