cancel
Showing results for 
Search instead for 
Did you mean: 

initial login and password for virtual SmartZone

Terrill
New Contributor

Hello,

I have been following the YouTube for installing vSZ on Azure. Yes, I know, this is a newer version of vSZ than what was installed in the video. By the way, this is the official Ruckus Wireless, not some other persons how to. Anyway, I have gotten to the point of starting the VM. I can successfully connect to the vSZ using SSH to start the initial setup. However, when I enter the "default" login and password, admin and admin, it says that it is incorrect. Any ideas? Thank you!

3 REPLIES 3

Ambika-leimapok
Moderator
Moderator

Hi Terrill,

The default admin credentials are as follows:

Default Admin Username: admin
Default Admin Password: admin
Default Enable Password: admin

Please confirm if you are accessing console or SSH. 

If you are accessing SSH then I assume you have set up the IP of the vSZ, if that's the case, try accessing WebUI and check if you could access the Set up wizard page

Leimapokpam Ambika
Sr.Technical Support Engineer
CWNA | RASZA | RACPA

I am using SSH, and it says that those credentials are not valid. Also just confirming this is the original setup, not trying to login to a vSZ that is already setup.

 

Terrill

Hi Terrill,

 

If you are able to SSH, please open a WebUI using https://<controller_IP>:8443  then walk through with the set up, there you would be able to set up the admin credentials 

Leimapokpam Ambika
Sr.Technical Support Engineer
CWNA | RASZA | RACPA