Ruckus R700 No Boot (Nvram/FLash Erased)

[Gabe237exe]

I may have accidentally erased the memory of the Ruckus R700 after flashing TTL firmware. I erased the memory without using the script, and since then I can't communicate with it via the console. Even the network cable no longer lights up; only the PwR LED remains lit. please help mee

[sagar_kuber]

Hi,

1.  What was the reason to do this action?
2. What were the steps taken to do this action?
3. Have you tried resetting the AP to factory default?

Regards
Sagar Kuber
Staff Technical Support Engineer- EMEA

[Gabe237exe]

1. Regarding the initial issue:

"I did it because I was unable to perform a reset and I couldn't access the router's web interface (http://192.168.0.1)."

2. Regarding the technical manipulation:

"I connected via the TTL port and accessed the terminal to inject the update using Serial and CoolTerm on Mac. However, instead of manually running the update through the Ruckus script, I ended up deleting the firmware."

3. Regarding the current status:

“The factory reset is no longer working.”