H510 Access Point Command Line Question

azupan

Hi

Is it possible to get the MAC address of wired client using the command line of a Ruckus H510 Access Point?

The H510 has 4 wired LAN ports.

I noticed that the command line has several 'get' commands available. But not sure if one of the get commands can show a mac address on a specific LAN port.

Thanks,
Adam

simon_louis

Hi Adam,

Please run the command get macdb <ifname>.

Example: get macdb eth3

This will show the mac-address that is learned on the particular eth port.

Regards,

Simon Louis