stand+alone+r300 not responding to url login page

Question

Trying to setup R300. Setup up pc using quick setup guide. Powered on AP to steady green. AP does not respond to url request at 192.168.0.1. However it does reply to pings. Please help

unknown · Answer

I was finally able to access the AP. I did as you suggested and connected to my switch and gathered the IP address of the AP from the table. I was able to login using the switch assigned IP address with the default user and password. I upgraded the firmware and configured the AP. I am logged into the AP now and browsing. Thanks for the help. Keep up the great advice.

michael_brado · Answer

Your PC address setup should be fine.

If you press the indented Hard Reset button (not Soft) for 8+ seconds before release, it should factory default the AP to 192.168.0.1 IP address.

Is your PC and the AP the only devices on the PoE switch?  How about when your PC goes thru the Pass-Through port?

Can you open an HTTP session to the IP address (login with 'super' uid, pw of 'sp-admin' if it comes up) using FF or Chrome?  
If so, what version code is it running?

unknown · Answer

PC preconfigured to static ip set to 192.168.0.22/255.255.255.0 with a gateway of 192.168.0.1. Connected AP uisng POE. AP did not respond to url request using IE. I was able to ping the AP.