AP shut down after power outage

Question

my smart home is dead. Nothing works. Switch is on but it’s not powering the APs.  Once I connect to the switch via Putty. What’s the command that I need to type to reboot my APs?

Orlando_Elias · Answer

Hey,

Log into the switch using Putty and run the following commands (assuming your AP is connected to port 1/1/1 in the ICX switch):

enable
configure terminal
interface ethernet 1/1/1
no inline power ------------> this disables power to the AP
inline power ------------> this enables power to the AP
end

Does it answer your question?
Let me know if you had any further queries.