Every time there is a power outage it will take at least a dozen or more reboots to get the switch to load into switch mode. I was looking through the forums and different articles. I have attempted to run a software recovery. However, following the direction from the following link https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-perform-a-Software-recovery-on-an-ICX7150-switch/m-p/47483
I get the "not alive" when I try to ping after following the steps in the above link.
I've read in other posts that the out-of-band port is not responding and that it since the software recovery is not working, this is an RMA. Any other suggestions or other things I can try? Or is this considered a RMA
software recovery not working
https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/ICX-7150-C12P-takes-multiple-attempts-to-boot/m-p/50214#M3367
Out band Port not Responding
https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/ICX7150-stuck-in-boot-mode-quot-is-not-alive-quot-when-trying-to/m-p/51583#M4280
No Kernel Image
not alive
current port lights and connections