POE Fatal message is flooding console on ICS7150-c12 switch

larry_speth

I have a Lennar smart house with a Ruckus 7150-c12 switch and a Ruckus R510 access point. After connecting to the console port I found the 7150 was continually send the message "PoE Fatal: Vmain (48V) fault has forced all ports on slot 0 to lose power". I was not experiencing any problems with any of the POE devices I have. I am researching a periodic problem of losing the internet connection for a few minutes and then it comes back. I tried a reset but after rebooting the 7150 resumes the continual error messages. I then tried a reset with a power on which my manual says should do a factory reset but again after reboot the error messages continue. Note that I have removed all cables other than the console cable from the 7150. I would like to update the firmware but can't get any commands into the console because of the stream of error msgs.

larry_speth

Thank you for your help but this has taken way too much of my time to try to fix the 7150. I have replaced the 7150 with another vendor's switch and have turned off the r510 and converted to a mesh system. Your company really needs to move away from the CLI control and switch to web control like most of the other network vendors.