I want to revert my Unleased to 100.x.x.x.x

Question

I installed the unleashed software in a R500 and was testing it.

I now want to revert the software back to 100.x.x.x.x but I cant seem to get it to revert to factory like when its originally at 100.x.x.x.x then its taken over by a ZD and changes it to 9.12.x.x.x.

In this configuration I just press the reset button for 10 seconds then I can http to the unit and install the 100.x.x.x. software.

When I do it with the unleashed it just resets to unleashed and I cant load a different software ...

Any help would be appreciated ..

Thanks

michael_brado · Answer

What does it say when you type 'get version' at the AP CLI prompt, that is the image that is running.

Type 'get director' and 'get scg' to determine if SCG service is running, which means the AP thinks it's under SCG control.

A factory default and WebUI access, is recommended to "upgrade" firmware to a Solo/Standalone image, if not on the 100.x code now.

unknown · Answer

I have an almost the same problem

I have an R500 and on confirming its version, it says

### Active SW ###
SW Version: 3.2.1.0.659

While the SW images on flash says
version: 100.0.0.0.127

what is the difference of the two as I can see them both on my R500

unknown · Answer

Answered my own question..

on the welcome screen after button reset press the sh ap info button then upgrade button. this will give you the option to upload the 100.x.x.x. file to the AP....