nav[aria-label="Primary Navigation"] { padding: 0; & ul { list-style: none; width: 100%; display: flex; flex-direction: row; justify-content: start; align-items: start; gap: 30px; padding: 0; & li { margin: 0; } & ul li { list-style: none; } } }

Cannot reach managed AP's via browser.

unknown

My R600's are managed by a ZD1200. I can't reach the individual AP's via their IP address in the browser. I'm guessing I missed something when I set up the 1200. Can someone point me to a global setting that enables this feature?

Thanks...

Find more posts tagged with

Accepted answers

All comments

unknown

The AP GUI is now disabled when you manage them through a ZD. You can SSH into the AP and turn the GUI on through the CLI but if the AP reboots then it will go back to the default.

unknown

Thanks, I guess that answers my question.

unknown

You can enable http/https access using:

ruckus> enable ruckus#debug
ruckus(debug)# remote_ap_cli -A "set http enable"
ruckus(debug)# remote_ap_cli -A "set https enable"

unknown

alan,

is this a bug or working as designed?

i think its a BUG..

unknown

sheldon,

what is the error message browser throws back?

unknown

It is not a bug the Web UI has been disabled on newer versions on ZD code.

Here is an extract from the 9.10 manual - page 394:

Note that because the AP is still in ZoneDirector-managed state, you cannot make
configuration changes via the web interface. Therefore you will need to proceed to
the next step and connect to the AP’s CLI to make changes.

The command that can be used in ZD cli is as follows

ruckus(debug)# rksap_cli -A "set https enable"

You can obviously still use the remote_ap_cli command if you wish.

Note: dependent on your environment I would be careful about enabling http 🙂

unknown

ok. thanks. Is this the case with AP's managed via Vscgs too?

unknown

That is correct its all about saving memory in the AP:

rkscli: get http
HTTP access is disabled
OK
rkscli: get https
HTTPs access is enabled
But the service is off, it is turned off to save memory once AP is managed by SCG!
If you need the service, please enable again by command "set https/http enable"!
OK
rkscli:

unknown

sean,

thanks...

May i know pls when this change took place as i am not able to see in the release notes of Ruckus Wireless TM SmartZone TM Software 3.1.1 Patch 1 (Refresh)

i will give these commands a shot and revert...

unknown

Its an undocumented feature, but a good one, as the Web UI is a waste of memory on AP's that are managed by a ZD/SZ/SCG

unknown

Im access ZD via console but i cannot enter into the global config. how can I fix it. we are also cannot acces the web portal.

some error :
possible SYN flooding on port 8099. Sending cookies.
Creating dumpfile: /etc/airespider/dump/rhttpd.dump
rhttpd registers crashdump usrcb

michael_brado

Reboot.

If that's the message you get on the console, your ZD may be bad. (RMA material)