7731 DFS and country code Croatia not existing

Question

Hi,

We are using 7731 in Croatia, but there is no country code Croatia to chose from.

Is it possible to put Croatia in country codes?

Is there a way to see what frequency rules apply to other countries in Europe (for example Germany) to check whether the frequency rules are more or less the same?

Are there any CLI commands for this?

Best regards,

Miro

unknown · Answer

I would agree with @Steve_Buyrum, however one must understand that allowed power output on non DFS (UNII-1) is only 200mW (23dBm) which is lower than on UNII-2e which is 500mW (27dBm). At least in the EU that's true.

If you can live with this ok, otherwise buy a higher gain antenna.

steve_byrum_508 · Answer

The best practice would be not to use DFS channels on a bridge if you can.

-Steve

unknown · Answer

Hi Miro,

on the other question, When Radar signal is detected then 7731 - root bridge will be forced to vacate the channel on which it was operating and go for a new channel irrespective whether auto channel or static channel was used. this is as per DFS requirement.

Hope it helps.

regards

Ramprakash

PS: Take a look at this doc which i refer whenever i am in doubt about DFS and its operation

http://www.nts.com/pdf/whitepapers/6_...