nav[aria-label="Primary Navigation"] { padding: 0; & ul { list-style: none; width: 100%; display: flex; flex-direction: row; justify-content: start; align-items: start; gap: 30px; padding: 0; & li { margin: 0; } & ul li { list-style: none; } } }

R510s through ICX7150-12p Not getting 1Gbps

zonablazer

Hey all I'm a frequent lurker but have not posted before here. I've got the Lennar at home setup with 3 R510s and an ICX7150. Currently I've got the APs connected to the switch in ports 2,4, and 6. Port 1 is my ISP which shows it at 1G-Full configured speed auto (I have fiber). My APs however are set to auto as well but are setting themselves to only 100-full. I've tried switching ports and manually setting the configured speed mode to 1G-Full-Master (this and slave are the only options for 1G). This caused the APs to drop connection and I had to go back in and reset it to auto.

I'm running the latest firmware on the APs and SPS08095d on the switch. Lines to the APs are Cat 6a.

Any thoughts at what could be causing this?

Find more posts tagged with

Accepted answers

dane_holland

Just a guess of course, but it may be the terminations of that Cat6. Personally, I'd get a pro out there to do line tests and see what they suggest. First, submit a ticket to the Lennar portal and see what they say. There may be a longer warranty on the wiring than what you realize. Who knows, the contractor they used may have a 5, 10 or lifetime warranty on that Ethernet.

All comments

dane_holland

I would take one AP down (assuming they're mounted on the ceiling) and put them on a short cat5e or 6a patch cable right at the switch, and see if you get the same results. Use the same port it's connected to now. That would rule out the home wiring being the issue. Test the AP that's least used, if that's possible to figure out.

Taking the APs down will probably require that you use the paperclip hole on the front of the AP to push in the latch release. I just moved from a Lennar home and it took me a long time to figure out how to get the darn things dismounted.

zonablazer

Will give that a shot. The lowest usage r510 is the master but I do have a secondary identified. I'll find a know good 5e or 6a and see how it responds. I appreciate the advice. I'm crossing my fingers that power outages didn't kill some ports.

zonablazer

Just connected the master via Cat5e and instantly got 1Gbps connection. If it's the lines throughout the house this is going to be a big problem. I think I'm past warranty work in my Lennar home for things like that.

dane_holland