BACK TO SUPPORT PORTAL
RUCKUS Technologies
Wired
Wireless
Cloud Services
Miscellaneous
RUCKUS Lennar Support
Lennar Knowledge Base
RUCKUS Lennar Support
Resources
Community
Technical
Register
RUCKUS Technologies
Home
Resources
Wireless Questions and Best Practices
Configure two R600s - configure them to work with eachother
unknown
I have never touched a ruckus before. I have two R600's (no additional management program or device). They are both direct wired to the LAN switch. Our firewall distributed DHCP. Do I need to do anything more than just put the same SSID and password for each to see each other or is there some additional mesh/bridge setup I need to configure?
Find more posts tagged with
Accepted answers
All comments
michael_brado
Unless using the Unleashed version of R600, Mesh capabilities require controller management (ZD or SZ).
If they are both wired to your LAN network, you can simply use them in Solo/Standalone mode.
Same SSID and authentication method, and while clients will re-authenticate when they roam between them,
you can support multiple clients.
unknown
Thanks - how do I tell if both are the unleashed version?
michael_brado
Ordering part number, on the bottom label will start 9U1-R600-xxxx for Unleashed, 901-R600-xxxx for standard Solo/Standalone image.
unknown
apart from ordering info, if your AP's are running firmware version like 200.0.9.9/ & 200.1.9.12 then you are running unleashed solution.
Quick Links
🗂️ All Categories
📄 Recent Posts
❓ Unanswered
🆘 Help
Tags
SmartZone or vSZ
RUCKUS Self-Help
Cloudpath
ICX
AP Management
vSZ
Access points
ICX Switch Management
Lennar homes
SmartZone
