nav[aria-label="Primary Navigation"] { padding: 0; & ul { list-style: none; width: 100%; display: flex; flex-direction: row; justify-content: start; align-items: start; gap: 30px; padding: 0; & li { margin: 0; } & ul li { list-style: none; } } }

One of my R510 APs won't upgrade and remains invisible to the Vsz

unknown

Hi folks. I recently purchased 25 APs R510. After doing some config (APgroups, WLAN, WLAN groups) on the controller i started to connect them to LAN. One of them won't upgrade and remains invisible to the Vsz. It's got the FW 3.6.1.0.354 and the Vsz has 5.0.0.0.675. The AP gets IP from DHCP and is visible in the Vsz CLI by the command "show ap [MACaddress]" there you can see IP adress and FW version. I've factory reset it and upgraded the FW to stand alone FW 104.0.0.0.1347 and then reconnect but no success. What happened was it degraded itself to the old FW version. I've also tried to SSH into it and the command "set scg ip " No luck whatsoever. Is there anything else I could try?

Find more posts tagged with

Accepted answers

All comments

pasquale_monard

What firmware is your zone configured for?
According to the 5.0 release notes it says that it must be 3.6.1.0.227...but I think 3.6.1.0.354 should work.

Try version 110.x if you can..

Any firewalls in between the AP and the controller for that particular AP?

unknown

OK, I'll try 110.x
No firewalls, the environment was identical to all 25 APs

unknown

Yes, the 110.x upgrade works fine. But still same result, the AP reverts to former FW version 3.6.1.0.354 when connected to the system and remains invisible to the Vsz.

michael_brado

Hm, heard this recently. Please try 104.x code on your R510 to connect to the SZ.

https://support.ruckuswireless.com/software/996-zoneflex-r510-indoor-ap-104-0-0-0-1347-ga-software-r...

harald_thomas_c

on the cli of the controller:
config
no ap-cert-check
end
save...
try again

unknown

Yes, it will be returned to re-seller.

unknown

this solution works fine for me, thanks