BACK TO SUPPORT PORTAL
RUCKUS Technologies
Wired
Wireless
Cloud Services
Miscellaneous
RUCKUS Lennar Support
Lennar Knowledge Base
RUCKUS Lennar Support
Resources
Community
Technical
Register
RUCKUS Technologies
Home
RUCKUS Technologies and Products
Access Points - Indoor and Outdoor
APs restarts quite often with various reasons (vSZ 3.5.1)
unknown
I have been experiencing problems with AP restarts for a very long time.
APs restarts quite often with various reasons:
was rebooted by the system because of [system recovery by watchdog]
was rebooted by the system because of [system fault]
was rebooted by the system because of [AP lost SCG more than 7200 seconds]
was rebooted because of [power cycle].
I have reviewed our PoE switches (Juniper EX3300), but didn't noticed any issues on their side.
APs are managred by vSZ version: 3.5.1.0.296, AP models are: ZF7372, R510, H510.
Has anyone on that forum experienced that kind of problems?
Find more posts tagged with
Accepted answers
All comments
sanjay_kumar
Hi Dawid,
Based on the AP reboot events you have mentioned, there could be many reasons for the issue to occur.
"AP lost SCG more than 7200 seconds" means there was no communication between the AP and vSZ. Or there could be packet drops between the AP and vSZ.
About the other events, we would need the AP support log to find the root cause.
I request you to please open a support case from the below link so that the support team can check on this.
https://support.ruckuswireless.com/contact-us
Regards,
Sanjay Kumar
unknown
Hello Sanjay,
Thank you for the response. Unfortunately we don't have valid support contract for this particular controller, that's the reason I'm asking this question on forum.
Dawid
unknown
Interesting to note, we too have seen APs seemingly randomly rebooting .. and yes, we ALSO have Juniper EX3300 switches.
unknown
That's interesting, and how did you deal with it?
unknown
We really haven't yet, but we are on code 5.1.2. I did find this post however, which might work for you.
https://forums.juniper.net/t5/forums/v3_1/forumtopicpage/board-id/switch/thread-id/19964/page/3
I also noticed LLDP doesn't properly negotiate speed with Ruckus as well, and had to manually hard set APs as AT power.
unknown
I'm not sure if this issue concerns PoE, because I have noticed that the problem is also present when ZF H510 is powered by local power supply and is connected to non PoE port.
Quick Links
🗂️ All Categories
📄 Recent Posts
❓ Unanswered
🆘 Help
Tags
SmartZone or vSZ
RUCKUS Self-Help
Cloudpath
ICX
AP Management
vSZ
Access points
ICX Switch Management
Lennar homes
SmartZone
