BACK TO SUPPORT PORTAL
RUCKUS Technologies
Wired
Wireless
Cloud Services
Miscellaneous
RUCKUS Lennar Support
Lennar Knowledge Base
RUCKUS Lennar Support
Resources
Community
Technical
Register
RUCKUS Technologies
Home
RUCKUS Technologies and Products
Access Points - Indoor and Outdoor
zf7323 not supporting 2.4ghz
unknown
I bought a used zf7363 to go along with my 8 existing zf7363 devices (connected with zonedirector). The "new" one doesn't seem to have 2.4ghz. It's connected to my zonedirector fine...it accepts new clients...but only 5ghz clients. I can't seem to find any checkbox that shows that it's disabled. It has the same firmware as all my other units (9.6.0.0.267). Am I missing something obvious?
Find more posts tagged with
Accepted answers
All comments
santosh_bittu
Hello Charles,
With reference to your post, if this AP is being managed by the ZD, you can view the AP's settings by looking under Configure > AP > Select the AP with the issue > Edit.
Here you have the 2.4 Radio setting and 5 G Radio setting, you have the option here to check if the WLAN broadcast is turned on or off.
Also you can look under Monitor > AP's > Click on the MAC of the problematic AP > Here on the AP page, you should have WLAN as one of the parameter and can check if the WLAN is deployed on the 2.4 G radio or not.
I also recommend that you open a support ticket and send the Support info file of the AP for us to check if there are any issues with the AP.
Hope this helps.
Cheers
Santosh
unknown
I know it sounds crazy, but the 2.4ghz options aren't there. (see image) when I click edit, it doesn't have 2.4ghz section of options the way the others do.
unknown
Hello Charles Spivey,
its a potential hardware issue. See if hard resetting the device corrects the issue or not. One of our community member reported similar one and resetting it corrected it. Give it a shot.
Hope it helps.
unknown
This is the Configure :: APs page.
@Bittu
instructed you to open the Monitor :: APs page and click on the MAC address of the AP in question
unknown
I did a full factory reset. I was prepared to reconfigure it, but I was quite surprised that the zonedirector found it and set it without any action on my part.
However, the 2.4ghz band is still missing. I have attached a screen shot of the monitor page, and you can see it only shows 5ghz.
santosh_bittu
Hello Charles,
This looks to be a hardware fault and the 2.4 GHz radio details are not being displayed. Since you have already done a reset and see the same issue I suggest that you open a support ticket and have the unit replaced.
One last thing you can try is to upgrade this AP in standalone mode to 9.6.2.0.13 version of firmware and check if this makes a difference, if the issue persists this is for sure faulty hardware.
Hope this helps.
Quick Links
🗂️ All Categories
📄 Recent Posts
❓ Unanswered
🆘 Help
Tags
SmartZone or vSZ
RUCKUS Self-Help
Cloudpath
ICX
AP Management
vSZ
Access points
ICX Switch Management
Lennar homes
SmartZone
