I cannot pair 2 ZoneFlex P300 Wireless Bridge,

Question

I cannot pair 2 ZoneFlex P300 Wireless Bridge, have completed all the config but the wireless status on the non-root bridge says the wireless is disabled

sanjay_kumar · Answer

Hi Alipate,If the above steps are followed and still have the issue, try setting the Root as Gateway on the Non root and check. I had this issue in lab setup and working on Gateway worked for me.Regards,Sanjay Kumar

unknown · Answer

Hi Alipate,- could you please verify all LEDs are Green and power is ON? - Also check you have same SSID and passphrase on both units.- what is the range between both links? what type of antennas do they have?- Please, go to Status --> Wireless , and in Site Survey side click on "ReScan". Do this on the Root Bridge (RB) and in the Non Root Bridge (NRB).- After checking all the above, connect to CLI and give us the output of this command, for RB and NRB,get scanresults wifi1get meshThanks.David.