Meshed ZD1100 | Migration - vSCG Controller Version 3.1.1.0.450

unknown

Suggestions Welcome. It’s about a meshed network, and the migration to vSCG Controller Version 3.1.1.0.450.  So far I've upgraded the software on the ZD1100 to the latest one I could find.  9.10.1.0.59 . On putty to the  AP’s ( ZF7982 ) The commands are not recognised. I started at the last one in the hop, thinking I could migrate from that point.  The only command that sort of works is the ( set director ip } But nothing happens. The site has been tested with other stand alone ZF7982 AP's, to the controller. I really do not want to pull everything down i.e rebuild.

michael_brado

From KBA-3377: How to update ZD mode AP firmware to support vSCG using LWAPP2SCG


Use the following steps to have the vSCG automatically upgrade your ZD-mode AP to a vSCG-mode AP.


Step 1: Preparing the vSCG to accept and convert ZD mode AP.
1. SSH into your vSCG


 

2. Get into the configuration context and enter the LWAPP2SCG config mode.


 



Sid-3rd-vSCG# config
Sid-3rd-vSCG(config)# lwapp2scg
 



3. Set the Policy to allow the vSCG to upgrade all AP, or only upgrade specific AP by mac.



Sid-3rd-vSCG(config-lwapp2scg)# policy accept-all
 
4. Exit the config context and save the change.


 

Sid-3rd-vSCG(config-lwapp2scg)# end
Do you want to update this context configuration (or input 'no' to cancel)? [yes/no] yes
 
Sid-3rd-vSCG#


Step 2: Directing your ZD-mode AP to connect to the vSCG's Control IP.
1. SSH into the AP

2. Issue the same "set director ip", but point it to the vSCG's Control IP.



    rkscli: set director ip 10.9.101.5

3. reboot the AP and it will connect to the vSCG and upgrade it's firmware.



    rkscli: reboot


Step 3: Direct your SCG-mode AP to your vSCG's Control IP.

1. Once the AP has finished upgrading and rebooting from (Step 2) SSH into the AP

2. Issue a "set scg ip" command to point it to the vSCG's Control IP. This

is because when the AP was converted from ZD-mode AP to vSCG-mode AP,

it took on the vSCG mode AP's Factory Default setting, meaning it doesn't know

the vSCG IP.



rkscli: set scg ip 10.9.101.5


NOTE 1: If the vSCG was deployed with only 1 Interface (recommended) then the Control, Management and Cluster IP are all the same.

NOTE 2: It is very important [required] to factory default the AP after every conversion process, form ZD to SCG or converting a SCG AP to ZD mode AP.