Hello, I have a new zone director 1200 because my old zd is was damaged and it replaced. And now I have 4 AP 7372 in my new ZD I can't seen, i think is because it has old version of firmware.
Is there a way that I can see them on the controller?
Hi Kelvin,
just look for a firmware that runs on zd1200 and supports your 7372.
Best regards
Harald
Looks like the new ZD is running a lot *newer* firmware then your old ZD. You will have to downgrade the ZD to a perhaps a 10.1.X.X.X software version. I would consider retiring those AP's. Especially if your clients now support Wifi 6 or even 802.11ac . 7372's are very good AP's for Dual Band N, but security and performance moves on,
Hi @kelvin_rodriguez
These AP's (ZF7372) are not supported on ZD code 10.2+ hence they will never work on any of those upper version. The maximum supported code for these AP's are 10.1.2.x where you can manage all below AP's. Please keep in mind if you go for a downgrade the existing configuration would wipe and go to factory default.
C110 E510H320 T300H500 T300eH510 T301nR300 T301sR310 T310cR500 T310dR510 T310nR600 T310sR610 T610R700 T610sR710 T710R720 T710sR730* ZF7781CMZF7055 ZF7782ZF7352 ZF7782-EZF7372 ZF7782-NZF7372-E ZF7782-SZF7982
Best Regards
Vinee
Thank you very much for all your comments, I will consider changing those APS
