How to convert a R750 from unleashed to standalone?

Question

It can find some previous posts about how to convert R710 from unleashed to standalone.I tried set the R750 unleashed to factory default and then using upgrade via web gui but it says R750_114.0.0.0.1392 is not a valid images.
would like to find some helps here.
Thanks

syamantakomer · Answer

Hi Ben,

If this just one AP on Unleashed network then yes, you can flash it to standalone version from Unleashed GUI directly (Ignore the warning). 
However, if there are more than one AP, then only existing master AP will be flashed and rest of the APs will still work as Unleashed (current master will be out of existing Unleashed network due to firmware mismatch and any other available member AP will become master).

Regards,
Syamantak Omer

unknown · Answer

Hi, just want to make sure that I'm using the correct method to update the fw. Could this file be uploaded to the unit by web gui directly? Is it corrected?

I would get the warning message "the updated software verison is 112.1.0.0.2146, doesn't match with Master AP's 200.8.10.3.243, please choose the same version as Master AP." I found previous post that said it may need to downgrade to the specific fw version so that unit can be flashed to standalone fw.

Thanks

Anusha_Vemula · Answer

Hi Ben,You can give it try with 112.1 firmware.https://support.ruckuswireless.com/software/2164-zoneflex-solo-access-point-112-1-0-0-2146-ga-softwa...

-Anusha