ZD1200 How to kill the bad signal client offline

Question

if an ap shows the RSSI value of a client is greater than 75dbm， which means signal very bad .

I dont know ruckus production very much , but i want to know how to kill the bad signal client offline , and then make sure that the client can connet the nearest ap when the movable client change its location .

How to set the ZD1200 , which can automatically implements the function .

sanjay_kumar · Answer

Hi Joe,

Below article explains about the table mapping the Roamfactor value to the SNR. Please check for your reference.

https://support.ruckuswireless.com/articles/000002637

Regards,

Sanjay Kumar

David · Answer

SmartRoam factor to 5 will make clients roam when SNR(also shown as RSSI) is bellow 20, so It is a good value to roam.

BSS Min Rate is good to 12 too.

Cheers.

David.

unknown · Answer

@david_saez thank you your answer.

i saw some cases after i posted this question.

right now i know how to tune the zd1200.

here are my set:

SmartRoam Factor is set 5,

and BSS Min Rate is set 12mbps.

what do you think.