nav[aria-label="Primary Navigation"] { padding: 0; & ul { list-style: none; width: 100%; display: flex; flex-direction: row; justify-content: start; align-items: start; gap: 30px; padding: 0; & li { margin: 0; } & ul li { list-style: none; } } }

R720 Unleashed fast flashing CTL LED

unknown

I am running newest Unleashed firmware. Was trying to do a factory reset but lost power before procedure can complete. Now I can't access GUI via 192.168.0.1 and CTL flashes fast. Can this unit be recovered?

Thanks.

Find more posts tagged with

Accepted answers

All comments

tony_heung

Best option is to open a support case with our technical team who can provide further assistance on the hardware reset and verify the flash status.

syamantakomer

Hi There.

Try doing a factory reset by pushing and holding reset button for 12 seconds. Once done, try to access default IP or DHCP assigned IP.

If still not working then open a case and they will verify.

Regards,
Syamantak Omer

unknown

Thanks, got it working now.

I have ran into another issue. I am using AC power supply (740-64277-001/ 48V .75A). In GUI, I got a warning stating "not enough electricity power provided". Do I need to configure the AP to recognize its getting AC power source?

Thanks again.

syamantakomer

Not required.

Wait for sometime, error should disappear automatically.

If not, then you may have to check.

Regards,
Syamantak

syamantakomer

Below is the recommended power supply and power specification for R720.

Image_ images_messages_5f91c485135b77e247acdefc_a1d84445200999f50a8bf53f5b30518b_RackMultipart202009041887915mp-125216ee-fc8a-4dc1-89d7-90022d9a3c98-379985570.png1599238606

Image_ images_messages_5f91c485135b77e247acdefc_a1d84445200999f50a8bf53f5b30518b_RackMultipart202009041887915mp-125216ee-fc8a-4dc1-89d7-90022d9a3c98-379985570.png1599238606

Regards,
Syamantak Omer

unknown

That's the power supply I got. I have two of them and both behaves the same. It has been a day since I installed it and saw this warning. I'll give some more time then. What should I check for if problem persists? Thanks.