Ruckus Unleashed R510 doesn't work at all?

Question

I've been testing unleashed on different model ap's for sometime now.. Have also deployed a cluster with R500 at a client site..
Today i tried R510 with unleashed firmware.. It proved to be extremely buggy and not working at all. Everything seems ok during config, but once it's up and running clients are disconnected almost every 5 sec.. Both laptop and mobile devices.. I had to unplug the ap's as i got disconnected all the time and replace them with R500, problem solved..
Hopefully a new software release will solve this? Or does anybody have any other suggestions?

unknown · Answer

I tested with to other R510's, and then it worked fine.. The two first ones i can't get working properly though.. strange, they work fine with a normal controller.. Anyways, this was just for testing purposes only. I'll try them again after the next software release..

nat_nat · Answer

I would suggest factory-reset the AP and try again. I have been running my network with R710 and R510 running 200.3.9.13.228 and working fine.

unknown · Answer

I've tested the same version on R500 and R310 without any issues..