AP's going into Mesh eMesh mode

Question

I have 12 APs' and 7/12 are showing in mesh/emesh status.  I am unsure why this is happening.  I understand that they can go into mesh mode if the cable fails but I can't imagine that 7/12 of my cables have failed. Is there any other reason this could be happening?

demetris_demetr · Answer

Are you sure that you don't have any single point of faillure among those 7 APs? Common Switch maybe?Are they on same floor/area? power faillure? I used to lose the APs of an entire floor of a hotel due to power faillure.