nav[aria-label="Primary Navigation"] { padding: 0; & ul { list-style: none; width: 100%; display: flex; flex-direction: row; justify-content: start; align-items: start; gap: 30px; padding: 0; & li { margin: 0; } & ul li { list-style: none; } } }

Not enough electricity power provided with AP warning

unknown

I have the issue on AP R710, 720, 750. Not enough electricity power provided with AP warning

issue. The issue started after updating the unleashed to 200.10 firmware. The issue is on the unleashed firmware 200.8 to 200.10.

On the firmware 200.7 didn't get the warning of "Not enough electricity power provided with AP".

Tried several PoE switches and PoE injector but it doesn't resolve. only after downgrading the unleashed firmware to 200.7 its getting resolve. pls suggest.

Find more posts tagged with

Accepted answers

All comments

unknown

It can take a few minutes for the AP to suppress this warning. Try waiting some times...

Regards

unknown

Hi paul,

No, The AP didn't suppress the warning in Unleash FW 200.8 to 200.10.

unknown

Strange. Did you check your POE injector or POE switch to check it's powerful enough ? the R7xx need more power than the other Ruckus AP.
I had to buy a GRT -480125A 48v Power Supply (60W)

unknown

Yes, Done every thing. I had tried more then 20 PoE intjector and switches.

The issue is not with any specific AP it with all the APs (R710, 720, 750 etc) working on unleashed firmware 200.8.x to 200.10.x

unknown

What are the power specs of your injectors ? 60W is not common actually

unknown

This is the specs. Input: 100-240VAC ~ 50/60Hz 1.0AOutput: 48VDC 1250mA (60W).

The APs are working perfectly with the lower ver of fw.

unknown

Same as mine. Sorry I won't be able to help you

sam_evans

Hi Rajiv,

Have you confirmed what PoE the AP is actually drawing?

Try forcing the AP PoE mode from "Auto" to "802.3at PoE" under Unleashed settings.

Kind regards,

Sam

unknown

@sam_evans yes, I checked. I have done the configuration for cli from power-mode auto to at but it always showing in consumption statute on af. Also tried to override the config from gui but it's not working at all.

sam_evans

Does it take 802.3at power on the earlier version of Unleashed with the same exact setup or is it 802.3.af power with no PoE warning?

unknown

yes, 200.7.x is working perfectly in all APs without any error/ warning.

From 200.8.x to 200.10.x its showing error/ warning.

eizens_putnins

Specification of 60W injector you mentioned looks suspicious:

Output: 48VDC 1250mA (60W). But probably it is just a marking.

Higher power injector normally use ~50-57 V, as with higher power also the voltage drop on the cable is higher. 100m loop sometimes may have resistance 8 Ohm, which may mean ~10 V voltage drop.

So if you have long cables (possibly, with higher resistance than usually too), you may not have enough power at the end of the cable, even if your injector is capable to provide 1.25 A.

If you have managed PoE switch, you can see what power is feeded from the port.

unknown

@eizens_putnins same specifications on my original Ruckus POE injector....