Cant access AP IP address R700 & R300 after ZD1106 firmware update (v9.10.2.0
build 84)

Question

Hi..I have a total of 11 AP (9 R700 & 2 R300) which are connected to ZD 1106.I just updated the firmware(v9.10.2.0 build 84) a few days ago. It fix most of my wifi issue (intermittent & lost connection to the internet). But i just found out today i cant access those individual AP ip address. Previously there's no issue but after update i cant login to AP webpage. has anyone got idea why and how to solve this? Plus apart from this, i need a recommedation + best practice guide on this as i want to compare with my existing setup. Thank you.

unknown · Answer

noted with thanks..last setup it was enable for each ap..but i do take your suggestion..better to turn off so that our internal user wont simply try to do something fishy..

albert_pierson · Answer

Hi,The remote_ap_cli command uses the AP MAC to identify and apply the AP CLI commands-a  is used to send the command to a specific AP-A sends the command to all connected AP's.Just a note - https and http were disabled on the AP's to save AP memory.  There are very few details available on the AP WEB interface that are not better seen on the ZD ... so it is recommended to keep it disabled.  I only enable AP WEB if I want to do a local firmware upgrade on an AP that I want to operate using a different controller platform (standalone, unleashed, SZ) as this is the easiest way to upgrade an AP.Hope this answers your questions.Thanks Albert

unknown · Answer

thank you..that works! 🙂edited: may i know if i want to direct use zd command what remote_ap_cli -A "set http enable" -A means? is it the IP Address? where can i get this full cli command reference?i've tried download here:https://support.ruckuswireless.com/documents/690-zonedirector-9-10-ga-cli-reference-guidebut keep getting the same page..nvm, i got it..