Ruckus R750 device support WPA3?
rkscli: set encryption wlan8Wireless Encryption Type: [0] quit, [1] OPEN, [2] WEP, or [3] WPAWireless Encryption Type: 3WPA Protocol Version: [0] quit, [1] WPA, [2] WPA2, or [3] AUTOWPA Protocol Version: 2WPA Authentication Type: [0] quit, [1] OPEN (PSK), [2] EAP (.1X), or [3] AUTOWPA Authentication Type: 1WPA Cipher Type: [0] quit, [1] TKIP, [2] AES-CCMP, or [3] AUTOWPA Cipher Type: 2WPA PassPhrase: "12345678"Enter A New WPA PassPhrase [8-63 letters], or Press "Enter" to Accept :WPA no errorOKrkscli: exitQuit:
The datasheet for the r750 says it supports wpa3, but there is no wpa3 in the settings.
What version of code is on the AP. I think within the vSZ at least, it needs to run at least 5.2.1. It is definitely an option with 5.2.2 vSZ code on the AP.
rkscli: get version
Ruckus R750 Multimedia Hotzone Wireless AP
Version: 5.2.2.0.1016
OK
rkscli:
rkscli: set encryption wlan 33
wlan: Invalid wlan interface name
rkscli: set encryption wlan33
Wireless Encryption Type: [0] quit, [1] OPEN, [2] WEP, or [3] WPA
Wireless Encryption Type: 3
WPA Protocol Version: [0] quit, [1] WPA, [2] WPA2, [3] AUTO (WPA+WPA2), or [4] WPA3
WPA Protocol Version: 4
Hi Suhyeon,
What Brian mentioned is correct. AP needs to be on a software version where WPA3 encryption is supported.
Below are the versions for different RUCKUS wireless controllers on which WPA3 is supported.
Unleashed: 200.8 and above
ZoneDirector: 10.3.0 and above.
v/SmartZone: 5.2.0 and above.
Thanks to reply brian, syamantak. The version is currently 114.1.0.0. It is being used by updating with solo AP standalone f/w without smart zone.What version should I download if I am using AP alone?
Hi Kim,
I don't think WPA3 is supported on stand alone firmware yet.
You may want to flash AP with Unleashed firmware 200.10 and configure the WPA3.
https://support.ruckuswireless.com/software_downloads/3059-ruckus-unleashed-ap-200-10-10-5-229-ga-software-for-r750
