Mounting recommendation needed on a parapet wall

Question

I need a recommendation please. I have a job that requires (4) 7762's be mounted on a parapet wall and then 'goose neck' so the AP will hang over the edge of the roof facing down. We've successfully used j-post/ satellite mounts previously, but in this case I need to overhang the roof. I need some specific mounting suggestions...

unknown · Answer

Check out camera mounts for parapets.  http://www.surveillance-video.com/acc...

Bosch

Pelco

All different brands and styles that allow the pipe to be turned in case you ever need to swing something over the wall.

Or use kindorf with U-Clamps to hold a mast in place.

unknown · Answer

Kind of need a better description of how you want to mount.

On top of the parapet?  On the inside of the parapet?  On a non-pen sled with an extension arm that reaches up over the parapet?

If mounting to the inside wall, I'd just use two J arm feet mounted to the inside and then use a conduit bender to put two 90 degree bends into a piece of 1-1/2" conduit so that goes up and over the wall.  Drill the bolt hole for the bottom foot so that the top bolt can be removed and the entire assembly can flip up inside the parapet for maintenance.    You could likely get away with only one foot but I'd recommend two.  If you can't bend conduit, you could use rigid 90s with couplers or have someone make the pipe for you.  Likely be easier to just stop in at your electricians shop and have them bend them for you.

steve_rosenthal · Answer

Is there anyone on the forums that has experience installing OUTDOOR WAPS on a building with parapet walls? I am really looking to the ruckus community for some suggestions ....