BACK TO SUPPORT PORTAL
RUCKUS Technologies
Wired
Wireless
Cloud Services
Miscellaneous
RUCKUS Lennar Support
Lennar Knowledge Base
RUCKUS Lennar Support
Resources
Community
Technical
Register
RUCKUS Technologies
Home
RUCKUS Technologies and Products
Access Points - Indoor and Outdoor
ZF7982 AP unable to setup wireless
unknown
Hi guys any help with setup, Logged in to set up the wireless but could not find where to enable the radio to set up my wireless, attached screenshot if anyone can help .planning on using it as standalone AP
Find more posts tagged with
Accepted answers
All comments
unknown
I believe previously this AP is controller managed. You need to use standalone AP firmware to use it standalone mode.
https://support.ruckuswireless.com/software/793-standalone-ap-software-9-8-3-0-14-all-aps
unknown
or
https://support.ruckuswireless.com/software/1017-zoneflex-solo-access-point-104-0-0-0-1347-ga-softwa...
martin_martin
Correct as Gupta and Thomas mentioned, you need to flash the AP to the latest standalone version which is 10x.x.x.x
regards
Martin
unknown
A little confused here what's the difference between 9.8.30.14 all aps vs Solo access point 104.0.0.0.1347 ga
unknown
A little confused here what's the difference between 9.8.30.14 all aps vs Solo access point 104.0.0.0.1347 g
martin_martin
104 is more new then 9.8.3
104 is also a firmware version that can be used standalone, and as code to connect to vSZ/SZ/SCG or to ZD. it has both controller clients in it.
regards
Martin
unknown
Is this firmware ok for standalone AP?
michael_brado
The first version is a ZoneDirector firmware image (9.8.3.x.x), as all Solo/Standalone AP images will start with a 100 series, like 104.x.x.x.x, or similar.
unknown
All good to go Thanks, Gupta.
That was too easy
unknown
Excellent all good to go.
Quick Links
🗂️ All Categories
📄 Recent Posts
❓ Unanswered
🆘 Help
Tags
SmartZone or vSZ
RUCKUS Self-Help
Cloudpath
ICX
AP Management
vSZ
Access points
ICX Switch Management
Lennar homes
SmartZone