ICX 7150 + r510 help!

steven_wong_hli

Bought a home with an ICX 7150 and 3 R510s. I forget what I did but I was able to get the APs on ruckus unleashed and set up a SSID. I bought another r510(4th AP) for a dead spot and plugged it into the ICX 7150. I opened up ruckus unleashed and do not see the 4th AP. The ICX 7150 is also not on the unleashed GUI(It was never on unleashed).

How do I configure the ICX 7150 to show up on unleashed(I am suppose to console into the switch? But I am not sure how to do it on a mac)? How do I configure the 4th AP to show up on unleashed to be set up(does the switch need to be added before this step)?

I am running ATT fiber so the switch is plugged into the ATT modem/router. I am also using MAC OS.

 

sunny_gupta

Hey there,

A couple of things..  You might want to ensure the new AP you purchased comes with Unleashed software (vs. Standalone).  The SKU should start with 9U1 (vs. 901).  Assuming you have an unleashed AP it may not be on the same code version as your existing network so might need to match the firmware first.

If is it a 901 non-unleashed AP you would definitely need to change its code first to Unleashed before it will join.

Same thing possibly with the ICX switch - I would ensure the Unleashed on the APs that you are running is newest as ICX Management was not available in older code - and again the switch also needs to be running the right software.

Sorry, I know this is all "upgrade your code!" but that is certainly where you might want to start in this case.