BACK TO SUPPORT PORTAL
RUCKUS Technologies
Wired
Wireless
Cloud Services
Miscellaneous
RUCKUS Lennar Support
Lennar Knowledge Base
RUCKUS Lennar Support
Resources
Community
Technical
Register
RUCKUS Technologies
Home
RUCKUS Technologies and Products
RUCKUS EOL Products
RUCKUS Diagnostics Dashboard (RDD)
Adding Wi-Fi controllers with smart redundancy setting to RDD
unknown
If I have 2 controllers setting with smart redundancy and management IP set. How do I add the two controllers in RDD?
Adding two individual controllers? or only add the management IP?
If adding two individual controllers, it seems that RDD can only login to any one of the controllers.
If adding the management IP only, I can only see 1 controller in RDD.
Thanks!
Kenneth
Find more posts tagged with
Accepted answers
All comments
sanjay_kumar
Hi Kenneth,
If you have Smart Redundancy with Management IP, then you can access the controllers with individual IP assigned to them or through the management IP.
However, if you are trying to access the Management IP, then whichever the ZD acting as "Active" will respond to it.
So, if you want to access only the Active ZD, then add the only management IP, if want to access both Active and standby in some cases, then add Management IP and individual IPs.
unknown
Hi Sanjay,
Actually, my problem is about adding Wi-Fi controller cluster to Ruckus Diagnostic Dashboard (RDD).
Thanks!
Kenneth
xang_xiong
Hi Kenneth,
Just to confirm, your controllers are ZD and not SZ or vSZ correct? If the controllers are Zone Directors, you will have to first create the Wireless Cluster in RDD. For the "System ID", you can pick any meaningful name (e.g. ZD-MQTT).
Once the Wireless Cluster is added, go ahead and create a Wireless Controller in RDD for each Controller you have. Make sure to set the Cluster for the Controller to the Wireless Cluster you created above. For the IP, use the IP for each Controller that you can SSH into as RDD will need to be able to SSH into the ZD controller to be able to pull the data/stats it needs.
Xang
syamantakomer
Hi Kenneth,
Add-on to what Xang suggested, please note below points related to ZD running in smart redundancy.
You can add ZD cluster (two ZDs in smart redundancy mode) using single management IP address (For this you have to make sure management interface is enabled on ZD and configured with an IP address).
If you add both the ZDs to RDD, then RDD will see them as two different devices, means comparing data for both may not be the same because only one of the ZDs will be active at a time for AP operations and management.
As a best practice, its better to use management IP or If you want the monitoring of both the devices, then add both ZDs.
Regards,
Syamantak Omer
unknown
Hi Omer,
Yes, what you mentioned is exactly I am facing. Actually, if adding both ZDs, I have also found that the information collect may not correct.
e.g.
- All APs are connecting to controller 1, however, RDD shows the APs are all connecting to controller 2.
- Always have alert that RDD cannot connect to controller 1 sometimes and then controller 2 sometimes.
Let me try to use management IP again~
Thanks!
Kenneth
syamantakomer
Hi Kennet,
Our RDD team is working actively to improve/enhance this but for now please use management IP of the ZD.
Let us know how it goes.
Regards,
Syamantak Omer
Quick Links
🗂️ All Categories
📄 Recent Posts
❓ Unanswered
🆘 Help
Tags
SmartZone or vSZ
RUCKUS Self-Help
Cloudpath
ICX
AP Management
vSZ
Access points
ICX Switch Management
Lennar homes
SmartZone
