Smart Zone 100 startup wizard NTP server dialog box

Question

If I assign the SZ a RFC1918 P address and do not allow it to access the WWW the initial configuration locks up.  If I leave the NTP server blank I cannot continue to the next step.  Is there a work around?

unknown · Answer

i also ran into this and i put some LAN IP... which allowed me to complete the wizard...once i was in... i changed the NTP correctly..

unknown · Answer

Do you have an internal server that can provide NTP. Does you firewall http NTP server enabled?
at worst case use setup a temporary device to act as you NTP server and ensure that it has had its time set correctly.