2nd cable causes wireless clients to not be able to connect r510

Question

I am testing a ruckus 510 in standalone
mode V: 106.1.0.0.469 I have managed to
set it up fine, plugged into a POE switch and it works great with one cable as
soon as I plug a 2nd cable in I cannot connect to the AP from any wireless
device. Both Ethernet ports are enabled and set up the same

Trunk Port

Bridge to WAN

802 disabled

VLAN 1

Am I missing something?

Thanks.

unknown · Answer

Make sure your AP model supports it and make sure the switch it is connected to is also set up correctly for link Aggregation. for looking into it and your quick response was driving me mad last couple of days! https://testmyspeed.onl/ 
https://scrabblewordfinder.vip/ 
https://solitaire.onl/

unknown · Answer

The 2nd cable was connected to the same switch, so I assume I was causing a loop on the network. Ok for some reason thought they did. cheers for looking into it and your quick response was driving me mad last couple of days!

mike_kuly · Answer

I just saw you are using an R510. That AP does't support Link Aggregation. The second port can be used to extend your network to say another computer or printer. Logically it is the same port.