using portfwd on Ruckus 7363

Question

I'm trying to use portfwd from the command line to forward ports on my Ruckus 7363. However, I can't seem to make a new rule. The prompt just keeps telling me the rule doesn't exist.

rkscli: set portfwd test-rule 2200 2200 both 192.168.50.42 2200 enable

the rule 'test-rule' does not exist

The help for this utility doesn't provide any information for creating a new rule:

rkscli: help portfwd

get portfwd : get portfwd

-- Display configured port forwarding rules

set portfwd : set portfwd  {options}

->   {tcp|udp|both}

-> {enable|disable|delete}

-- Configure a port forwarding rule

The help mentions an optional argument {options} but none of the options are listed. Can I get help using the utility or port forwarding on this router in general?

For reference, here is my output from get version:

Ruckus 7363 Multimedia Hotzone Wireless AP

Version: 9.4.3.0.12

tee_chong_lee · Answer

hi keith,

how do i use the set interface cli to set port forwarding to an internal IP at a specified port? I can't figure out from the syntax given in the cli guide.

keith_redfield · Answer

Technically...we don't support the CLI on standalone APs. That said, I *think* you might be using a deprecated command. Try using set/get interface instead.

get interface []

set interface  [forward ] type  untag {|none}

[vlans ]

unknown · Answer

Still trying... Realized I might have been using the command wrong. Even tried rebooting. Still no luck. =[

rkscli: set portfwd bender-ssh 2200 2200 tcp 192.168.50.42 2200

+ /etc/init.d/nat portFw_enable br0

+ /etc/init.d/nat hotspot br0 10.1.0.1

OK

rkscli: set portfwd bender-ssh enable

+ /etc/init.d/nat portFw_enable br0

+ /etc/init.d/nat hotspot br0 10.1.0.1

OK

rkscli: reboot now

OK

rkscli: get portfwd

Currently configured port fwd rules

OK