LACP with R610

Question

Hi, in the wireless network are 2 R610 and 8 R600, and i need to know if is possible configure LACP on R610 through of two ethernet ports? or what is the purpose of two interface ethernet?

unknown · Answer

@abi  is it also possible with the r510? It also has dual ports.

unknown · Answer

Hi Salvador,

Yes, that should be it.

Regards,

Abilash PR.

unknown · Answer

Hi Abi,i has been research about of procedure. i found this instructions for CLI##To configure the AP for link aggregation:    1. Verify that the AP power mode is 802.3at:content_copy zoom_out_maprkscli: get power-modePoE Configured Mode      : AutoPower Consumption Status : 802.3at PoE+OK    2. Create the bond0 profile for the LAG group and add the two physical Ethernet interfaces to the LAG.content_copy zoom_out_maprkscli: set bond bond0 add eth0rkscli: set bond bond0 add eth1When you create the LAG group, LACP is automatically enabled.     3. (Optional) Set the transmit hashing option to Layer 3 and Layer 4 to optimize hashing for common enterprise WLAN environments.content_copy zoom_out_maprkscli: set bond bond0 xmit-hash 1###this is corrrect?