Update zf7321 standalone, root certificate from Nov 2016

Question

Hello,

Anyoone know if I can update the root certificate on standalone zf7321 as "certificate verificaton status" shows PASSED so I cant access the CSR part for the cert replacement process.

Don't even understand why it show PASSED in the first place but I guess the chain checks out.

Software Version:100.1.0.0.432

Re

K

syamantakomer · Answer

At least we tried everything.

It is weird because in standalone version, you should be able to update the cert from controller GUI.

kf · Answer

Thanks Syamantak,

I tried most of the version I had from 9.8 to 10.1 the linked version and no change in the ability to do the CSR or do anything about the offending cert.

I´ve given up on looking into this further.

syamantakomer · Answer

Hi Kjartan, What is the current firmware on ZD7321? If it is lower than 9.x, you have to upgrade it to 100.x and then it will give you the option update the cert from GUI. If GUI is also not giving you option to upgrade firmware, use AP CLI and FTP/TFTP to upgrade the firmware. Download the 100.x standalone version from the below link. https://support.ruckuswireless.com/software_terms_and_conditions/838-ruckus-zoneflex-solo-indoor-access-point-100-1-0-0-432-ga-software-release-zip Procedure FTP: * Download the appropriate firmware file from www.support.ruckuswireless.com and put it on FTP server's root folder * SSH to AP and type below commands (Make sure that you are able to ping the FTP server's IP from AP CLI): fw set control zf7321_100.1.0.0.432.Bl7 (This is the file name of the firmware in FTP server). fw set proto ftp fw set host xxx.xxx.xxx.xxx (Where x.x.x.x is IP address of the FTP server) fw set user xxxx (Where xxx is user name of the FTP server) fw set password xxxx (Where xxx is password of the FTP server) fw up reboot Procedure TFTP: * Ensure that the board is able to ping the TFTP server Place the image in TFTPROOT directory (typically /tftpboot) on the host TFTP server * Run the following commands on rkscli prompt to flash an image using TFTP: fw set proto tftp fw set host fw set control (path/Name of the image file, eg. ap-arm-qca-wsg/rcks_fw.bl7) fw update reboot Once above is done, AP should give you option for cert update using GUI.