BACK TO SUPPORT PORTAL
RUCKUS Technologies
Wired
Wireless
Cloud Services
Miscellaneous
RUCKUS Lennar Support
Lennar Knowledge Base
RUCKUS Lennar Support
Resources
Community
Technical
Register
RUCKUS Technologies
Home
RUCKUS Technologies and Products
Access Points - Indoor and Outdoor
How To Set Up Second AP T300 to join Mesh?
unknown
Hello...
I have 2 T300 APs, I configure the first one as unleashed, I already set up the mesh, how to make the second AP join the mesh from the first AP? do I need to make unleashed or standalone mode? and what next to do?
Find more posts tagged with
Accepted answers
All comments
unknown
Make sure you have mesh enabled on your Master AP: Admin & Services>System>Mesh>Mesh Settings. Take your second AP and connect it to the same LAN as the Master AP.
Log into your Unleashed dashboard and verify your second AP has been discovered (allow a few minutes).
Disconnect from the physical LAN and it should create a mesh connection.
martin_martin
Offcourse the second AP also needs to have unleashed software on it, otherwise the master node cannot understand it. connect the second on wired first, let it be discovered and added, when fully up, you can remove the wire and it will mesh to the master node.
regards
Martin
unknown
Thanks for your response
So, I need to make the second AP as unleashed too? And do I need to enable mesh on the second AP?
unknown
Thanks for additional response
Do I need enable mesh on second AP? or the second AP will automatically added into mesh from the master AP?
unknown
You only have to enable it in your Unleashed dashboard. You will have to restore to factory default if you decide to disable mesh in the future.
Quick Links
🗂️ All Categories
📄 Recent Posts
❓ Unanswered
🆘 Help
Tags
SmartZone or vSZ
RUCKUS Self-Help
Cloudpath
ICX
AP Management
vSZ
Access points
ICX Switch Management
Lennar homes
SmartZone
